Trouble Shooting Guide

PAIRING

This process is the match the PU with camera and movement sensor mat

so that they can communicate with each other while no other devices (even

baby monitor of identical model) can interfere with you or receiving your signal.

The PU and camera are already paired when they are shipped out from

factory. However, it is necessary to perform pairing again when an extra

camera is added to work with PU.

1. Press and hold the button 10 of PU.

2. Rotate the side ring 16 to switch on unit, then release button 10

after hearing a beep. The icon screen will show a “1” and a “ ”

flashing.

3. Press and hold the volume down – button 8 on one of the camera

while switching on the unit by long press of power button 1 until the

night light 5 starts flashing. This indicates the camera has entered

pairing mode.

N.B. Be sure not to set two cameras into pairing mode at the

same time.

4. Short press button 10 on PU, two beep sound will be heard which

indicates pairing become successful. The night light 5 will go off while

the “ ” will stop flashing. This camera is assigned as camera no.1.

5. Now repeat step 3 on the other camera after switch off camera 1.

6. Short press button 15 on PU and the icon screen will show a “2” and

a “ ” flashing.

7. Short press button 10, two beep sound will be heard. The night light

5 on this camera will go off while the “ ” will stop flashing. This

camera is assigned as camera no. 2.