Trouble Shooting Guide

8. Switch off all units and switch on again, the baby monitor is ready for

operation.

9. The pairing between camera and movement sensor mat should be

performed after the successful pairing between camera and PU or

otherwise the system will not operate properly.

10. Press and hold the volume up + button 8 on camera while

switching on the unit by long press of power button 1 until the power

indicator 2 starts flashing.

11. While holding down the alarm hold button 21 , switch on the

movement sensor mat by turning the knob 20 clockwise, two beep

sound will be heard in camera, indicating pairing is successful.

12. The mat is now ready for operation, probably you will hear the

breathing alarm in PU (if the baby breathing alert function is set to ON)

after 20 sec in case nothing is placed on the mat. Slight tap the mat

few times and the alarm will stop, this show the system is working

properly.

N.B. When it is no longer necessary to monitor the baby’s

breathing as he grows older, the movement sensor mat is

required to unpair from camera to avoid unnecessary alarms. To

achieve this perform pairing process between camera and PU by

repeating above steps 1- 8 but leave out steps 10 -11.