User Guide

SURROUND EFFECTS
Delay Time Setting Delay Time
In the surround modes, the sound is delayed from Press the SPEAKER SET-UP button to set the
the front to the rear speakers. The optimum delay delay time in the DOLBY DIGITAL/DOLBY PRO
time will depend on acoustic properties of the room LOGIC modes. Adjust the delay time for the center
and the distance of the listening area from the speakers. or rear speakers by using the:
It is recommended that you try different delay times 1. MULTIJOG/PRESET DOWN/UP on the system or
to obtain the best effect. The delay is digitally by using the ADJUST +/- buttons on the remote.
synthesized, for the highest sound quality with
minimum noise and distortion. 2. Then confirm it by pressing the CLEAR/SET button
on the system or by pressing the SET button on the
The delay time can be set independently for each remote control.
Surround mode with the current setting shown on
the display. Surround Mode Adjustable Range
DOLBY DIGITAL 0 ~ 15 ms in 1ms step (S-Delay)
0 ~ 5 ms in 1ms step (C-Delay)
DOLBY PRO LOGIC 15 ~ 30 ms in 1ms step (S-Delay)
ADJUSTING CENTER AND REAR CHANNELS
TEST TONE adjustment NOTE: Front left and right speaker levels are adjusted
When your system is in the Dolby Pro Logic, Dolby 3 by using the master volume control and balance
stereo, Dolby Digital, HALL or THEATER surround control. You can adjust the individual levels of the
sound mode the TEST TONE can be used to adjust center, rear left, rear right and subwoofer by using the
the volume levels for the center and rear channels. following procedure .
According to the position of the SURROUND MODE,
the test noise will be heard from each speaker for While the appropriate speaker’s test noise is
about 3 seconds in the following cycle. emitted, adjust the volume level by using the:
A test noise will travel ... Front Left speaker ... Center 1. MULTIJOG/PRESET DOWN/UP on the system or
speaker ... Front Right speaker ... Rear Right by usingthe ADJUST +/- buttons on the remote.
(Surround) speaker ... Rear Left (Surround) speaker
...Sub Woofer ... and continue to repeat until the 2. Then confirm it by pressing the CLEAR/SET button
Test Tone button is pressed again. on the system or by pressing the SET button on the
remote control.
As the test noise is being heard you may adjust the
speaker volume of the center, rear (surround) and NOTE:
subwoofer speakers to the level most suited to your This unit is manufactured under license from Dolby
listening area or preference. Laboratories.“Dolby”, “Pro Logic”, and the double-D
symbol are trademarks of Dolby Laboratories.
14