User Guide

21
16:9 WIDE (Widescreen) — If you have a widescreen TV set,
use this setting. The DVD plays in full size. (You must also
set your widescreen TV to “full size”).
SELECTING DIGITAL AUDIO OUT
Each DVD has a variety of audio output options. If you
connected a Component to the receiver’s digital optical jacks
(see “Connecting a Digital (Optical) Audio Component” on
Page 7), you might have to change the digital audio output
setting. Set the player’s Digital Audio Output according to the
type of audio component you use.
1. Press
SET UP
.
2. At the setup screen, press
or to select DIGITAL OUT
3. Repeatedly press
ENTER
to select the desired output (PCM
or BITSTREAM) , then press
ENTER
.
BITSTREAM — Select BITSTREAM if you have an amplifier
or other equipment with DTS decoder or Dolby Digital
decoder connected to the receiver.
— Select PCM if you have an amplifier or other
equipment with linear PCM only (or an MD recorder or a
DAT deck) connected to the receiver.
Caution:
If an active digital audio output signal is supplied to a
receiver or other equipment without a corresponding digital
decoding capability, a very loud noise might be produced
which could permanently damage your speakers.
Note: When you make a digital recording from a CD to your
audio CD receiver, entire CD tracks are recorded as one track
because there is no track information.
SELECTING PROGRESSIVE SCAN MODE
Note: To use Progressive Scan on the DVR100 you will need a
digital TV (DTV).
This unit is equipped with progressive Scan(P-Scan)Video Output.
The P-Scan feature only works when connected to a digital TV with
the correct 3-wire video cable.
To turn on the Progressive Scan output, press "SET-UP" and then
press the "GUI" buttons on the remote control to select
"P-scan" On or "P-Scan Off" in the display. Once you have selected
"P-Scan On" or "P-Scan Off" press "SET-UP" again to save and exit.
Important: If the P-Scan output is turned on when connected to a
standard analog TV, no picture can be seen. To restore the picture,
turn the P-Scan output off.
Using the Progressive Scan feature will allow you to see the complete
image displayed on your TV screen with more detail and smoother
motion when watching moving images.
This progressive scan system with 480 lines of resolution is
called, "480"