User Guide

11
Connection 1
Basic TV Connections
Make one of the following connections, depending on
the capabilities of your existing equipment. The
connections are listed in order of quality of picture with
the best possible last. Additional information on each
connection type is provided below:
RF coaxial connection
ANTENNA to DVD/VCR.
Connect the Antenna to the RF ANTENNA IN jack
on the DVD/VCR.
Connect the RF ANTENNA OUT jack on the
DVD/VCR to the antenna in jack on the TV using
the 75-ohm Coaxial Cable supplied .
Note:
If you use this connection, tune the TV to the
DVD/VCR’s RF output channel (CH 3 or 4).
The RF output channel is changed between CH 03
and CH 04 by switching the channel switch on the
back of the unit.
A
B
A
Audio/Video Connections
Connect the VIDEO OUT MONTOR jack on the VIDEO
INPUT jack on the TV using the video cable supplied .
Connect the Left and Right AV2 AUDIO OUT jacks. on
the DVD/VCR to the AUDIO INPUT jacks on the TV
using the supplied audio cables .
CAUTION:
< Switch off the power to all equipment before making
connections.
< Read the instructions of each component you intend
to use with this unit.
< Be sure to insert each plug securely. To prevent hum
and noise, avoid bundling the signal interconnection
cables together with the AC power cord or speaker
cables.
B
2
C
1
ANTENNA
INPUT
VIDEO
INPUT
Pr Pb Y
S-VIDEO
INPUT
COMPONENT/PROGRESSIVE
SCAN VIDEO OUT
AUDIO INPUT
TV
REAR PANEL
A B C
OR
Antenna
Cable TV
Wall Jack
Antenna
Flat Wire
(300 ohm)
300/75 ohm
Adaptor
(Not supplied)