User Guide

13
REMOTE CONTROL OPERATION
A QUICK LOOK AT THE REMOTE CONTROL
OPERATING RANGE OF THE REMOTE
CONTROL
The remote control may not work properly if:
• There are obstacles between the remote control and the
receiver’s remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control.
BAND
/
— Selects AM or FM band
while using the tuner.
FM MODE
— Selects FM mono or stereo mode.
MEMORY
— Press to memorize the desired
station frequency.
TUNING MODE
— selects and deselects pre-
set mode.
PRESET – / +
— During AM or
FM reception, you can scan
through other frequencies or se-
lect the preset numbers.
MUTE
MUTE
— Press to
immediately stifle the
sound level.
appears on the re-
ceiver’s display pan-
el. To restore the
sound, press again.
SLEEP
— Press to set the sleep time.
TONE
— Lets you adjust the low fre-
quency level (BASS) with or . You
can also adjust high frequency level
(TREBLE) with or .
TEST TONE
PRO LOGIC,
THEATER, HALL, or STADIUM.
— Turns on or off the test tone func-
tion in DTS, DOLBY DIGITAL, or PRO LOGIC mode.
The test tone is output from Front L speaker, Cen-
ter speaker, Front R speaker, Surround R speaker,
Surround L speaker, (Subwoofer speaker when
Subwoofer is on).
SURROUND
— Repeatedly press to
change the surround mode to
Note:
SURROUND
works to change to stereo.