User Guide

16:9 WIDE (Widescreen) — If you have a widescreen TV set,

use this setting. The DVD plays in full size. (You must also

set your widescreen TV to “full size”).

SELECTING DIGITAL AUDIO OUT

Each DVD has a variety of audio output options. If you

connected a Component to the receiver’s digital optical jacks

(see “Connecting a Digital (Optical) Audio Component” on

Page 7), you might have to change the digital audio output

setting. Set the player’s Digital Audio Output according to the

type of audio component you use.

1. Press

SET UP

2. At the setup screen, press

or to select DIGITAL OUT

3. Repeatedly press

ENTER

to select the desired output (PCM

or BITSTREAM) , then press

ENTER

BITSTREAM — Select BITSTREAM if you have an amplifier

or other equipment with DTS decoder or Dolby Digital

decoder connected to the receiver.

PCM — Select PCM if you have an amplifier or other

equipment with linear PCM only (or an MD recorder or a

DAT deck) connected to the receiver.

: :

: If an active digital audio output signal is supplied to a

receiver or other equipment without a corresponding digital

decoding capability, a very loud noise might be produced

which could permanently damage your speakers.

: When you make a digital recording from a CD to your

audio CD receiver, entire CD tracks are recorded as one track

because there is no track information.