Explosion diagram specification 1 3 5 7 9 11 13 15 17 19 21 LCM Assembly Power Key Front Flash Lens Audio Jack Rubber Motor Back Camera Main PCB Fingerprint Module Battery Lowhousing Assembly Silver Screw 2 4 6 8 10 12 14 16 18 20 22 Front Housing Assembly Volume Key MIC Rubber Coaxia Cable Sidkey FPC PCBA Speaker Front Camera Proximity Sensor Rubber Black Screw Battery Cover Assembly
Know your phone Front camera Volume key Power key Return key Recent key Home key
SIM/SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). 1. Please remind the front and back of the plug. 2. Use only TECNO charger and cables. Other chargers or cables may damage the device or your device. This will invalidate your phone warranty.
FCC Caution Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Information to the user.
FCC RF Exposure Information and Statement The SAR limit of USA (FCC) is 1.6 W/kg averaged over one gram of tissue. Device types: K8(FCC ID: 2ADYY-K8) has also been tested against this SAR limit. The highest SAR value reported under this standard during product certification for use at the ear is 0.59W/kg and when properly worn on the body is 1.12 W/kg. This device was tested for typical body-worn operations with the back of the handset kept 10mm from the body.
