Explosion diagram specification 1 3 5 7 9 11 13 15 17 19 21 touch screen LCD Front_housing_assy Front_camera_assy Main_PCBA Side_key_FPC_assy BACK_LED_Lampshade Battery_Cover_assy Side_key_assembly Sub_PCBA MIC_Rubber 2 4 6 8 10 12 14 16 18 20 22 Front_LED_Lampshade IR_Rubber Audio_Jack_rubber Receiver Rear_camera_assy Battery_package BACK_housing Camera_lens Speaker Vibration_motor
Know your phone Front camera Volume key Power key Return key Recent key Home key
SIM / SD card installation 1. Power off mobile. 2. Refer to the following picture for SIM / SD card installation.
Charging the phone You can charge your device using a charger or by connecting it to the computer using a USB cable (comes with the phone). 1.Please 1.Please remind the front and back of the plug 2.U 2.Use only TECNO charger and cables. Other chargers or cables may damage the device or your device. This will invalidate your phone warranty.
FCC Caution. Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the condition that this device does not cause harmful interference. Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
-Consult the dealer or an experienced radio/TV technician for help. Specific Absorption Rate (SAR) information: This Mobile phone meets the government's requirements for exposure to radio waves. The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
from the body. To maintain compliance with FCC RF exposure requirements, use accessories that maintain a 10mm separation distance between the user's body and the back of the handset. The use of belt clips, holsters and similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these requirements may not comply with FCC RF exposure requirements, and should be avoided. Body-worn Operation This device was tested for typical body-worn operations.