User`s manual

14 INSTALLATION INSTRUCTIONS
RECEIPT OF UPS
Inspect the UPS upon receipt. If the UPS has been damaged during shipment, keep the box and
packing material for the carrier. Notify the carrier and dealer immediately. Make sure the
following is in the box
• EVO RT UPS
• UPS output cable
• AC input power cord
• Phone cable
• 2 pedestals for the TOWER positioning
• 2 metal brackets with handle for 19” RACK mounting
• UPSILON 2000 software for UPS management (including CD-rom and RS-232 cable)
• User’s manual
We advise you to keep the original box in a safe place and use it in case the UPS needs to be
sent to the service for maintenance.
PLACEMENT
We advise you to place the EVO RT as close as possible to the AC input line and to the
equipment that needs to be powered. The UPS is designed to operate in protected environments
(for example: offices).
This UPS should be installed indoors with adequate airflow and free of contamination. Locate it
in a clean and indoor environment, free from moisture, flammable liquids, and direct sunlight.
In all circumstances, see the TECHNICAL CHARACTERISTICS chapter for environmental
specifications and check that the selected area meets these criteria.
EVO RT requires at least 20 cm of unobstructed space all around in order to be properly
ventilated.
The UPS is designed to be fitted inside 19’” Rack cabinets;
in such case the cabinet must be
provided with forced ventilation.
EVO can be installed in a vertical (TOWER) position through included pedestals.
Do not obstruct ventilation holes and do not insert objects or liquids in the ventilation holes.
Do not place any object on top of the EVO RT UPS. Do not pour liquids, flammable
gases, or corrosive substances near or on the unit.
FIRST START-UP
The first start-up procedure is very simple. We advise you to follow the steps explained below.
1. Through the supplied cable connect the UPS to the AC line outlet. It is mandatory to
ground the outlet according to the Safety Standards. Carefully check the grounding,
make sure that the utility power is available, and that its range falls within the UPS
specifications.
2. Switch the UPS ON and see that it operates correctly. Check that the UPS does not signal
any sort of anomaly. Wait for the correct switching to LINE mode and make sure that the
cooling fans are set in motion. Leave the UPS in LINE mode for at least 8 hours in order to
completely recharge the batteries.
UPS EVO RT 12 User’s manual