Operation Manual

When you press the Start/Pause button during a wash cycle, the selected program

indicator will stop blinking and the buzzer will sound each minute until the Start/Pause

button is pressed and the wash cycle resumes.

Be very careful when opening the dishwasher door during a wash cycle as hot water and

steam may cause injury or burns.

1. A wash program should only be modiﬁ ed if it has been running for a short time.

Otherwise, the detergent may have been released and wash water drained.

If this is the case, reﬁ ll the detergent dispenser prior to starting another program. (Refer

to page 9).

2. Press the Start/Pause button so that the dishwasher enters stand-by mode. Press and

hold the program button in for at least 3 seconds. You can now change the selected

program. (Refer to page 12).

NOTE

If you open the door during a wash cycle, the dishwasher will pause. The program light will

stop blinking and the buzzer will sound every minute until you close the door. After

you close the door ,the dishwasher will continue the wash cycle after 10 seconds.

Items can be added at any time to a wash that has begun. It is not recommended,

however, to add items once the detergent has been released into the wash cycle. The

additional items will not receive the minimum required detergent for a complete clean.

To add items once a wash cycle has started:

1. Press the Start/Pause button.

2. Slightly open the door (<50mm) and wait for the dishwasher to stop.

3. Once the wash arms have come to a complete stop, open the door completely.

4. Add the additional items to the top or bottom baskets.

5. Close the dishwasher door.

6. Press the Start/Pause button. The wash cycle will resume after 10 seconds.

When the wash cycle has ﬁ nished, the buzzer will sound for 8 seconds, then stop.

1. Press the power button to switch off the dishwasher

2. Shut off the water supply

3. Open the dishwasher door. Wait for a few minutes before unloading the dishwasher

to avoid handling the dishes and utensils while they are still hot and more susceptible to

breakage. This will assist in the drying process.

4. Switch off the dishwasher at the mains power source.

5. Carefully open the door completely.

NOTE: Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool

down for aprox. 15 minutes before removing from the dishwasher baskets.

6. Unload the dishwasher. It is normal to ﬁ nd the dishwasher is wet inside.

Empty the lower basket ﬁ rst and then the upper basket. This will avoid water dripping from

the upper basket onto the dishes in the lower basket.

START/PAUSE BUTTON

CHANGING THE PROGRAM

ADDING ADDITIONAL ITEMS

AT THE END OF THE WASH CYCLE

CAUTION