Operation Manual

POWER CONNECTION (CONT.)

POWER CONNECTION - GROUNDING

WATER CONNECTION

CHECK DISHWASHER IS PROPERLY GROUNDED BEFORE USE

Ensure the voltage and frequency of the power being supplied corresponds to

those on the rating plate. Only insert the plug into an electrical socket which is earthed

properly. This dishwasher is designed to operate on a single phase power supply within a

voltage range of 220~240V/50Hz. If the supply cord is damaged, it must be replaced by

the manufacturer, its service agent or similarly qualiﬁ ed ed persons in order to avoid a

hazard.

This appliance must be earthed. In the event of a malfunction or breakdown, earthing will

reduce the risk of electric shock. This appliance is equipped with a power cord with an

equipment-earthing conductor and an earthing plug. The plug must be inserted into an

appropriate outlet that is installed and earthed in accordance with local standards and

requirements.

CONNECTING THE SAFETY SUPPLY HOSE (AQUA-STOP)

The appliance must be connected to the water mains using a new

hose set. An old hose set should not be reused.

Water pressure must be between 0.04 MPa and 1 MPa.

If the pressure is below the minimum requirement, please consult your

local water supplier, authorised plumber or TECO service department

• Improper connection of the equipment earthing conductor may increase the risk of an

electric shock.

• Check with a qualiﬁ ed electrician or TECO service if you have any doubt about the

electrical safety of power source or power plug.

• Do not modify the plug provided with the appliance. If the plug does not ﬁ t properly in the

outlet, please consult a qualiﬁ ed electrician.

WARNING

Fig.18

Pull the Aqua-stop completely out from storage compartment located at rear of

the dishwasher.

Tighten the screws of the Aqua-stop hose to the faucet with 19mm (3/4inch)

thread.

Turn on the water to full before starting the dishwasher.

Step 1

Step 2

Step 3