User Manual

Chapter 5: HCI Testing Procedure

The HCI Testing procedure provides instructions for creating point-to-point ACL links

between two Bluetooth Module Evaluation Boards.

System Requirement for Bluetooth Module HCI Test Program

Before using HCI Test Program for testing, please make sure the PC or Notebook PC meets

the following requirements in order to run the software properly:

1. To create connection, it requires two units of PCs to perform the testing procedure

2. Hardware: Pentium Class PC, CPU speed 200MHz or above, with RS-232 (for UART

interface testing) and USB port (for USB interface testing).

3. Operating System: Windows 98SE.

Note: For commercialized features requires third party USB driver & software.

Create the ACL Link

Once the device driver & firmware for TECOM Bluetooth

Module BT3010 for USB or UART

interfaces has been installed into two PC with Windows 98SE installed, one for Master, the

other one for Slave, the steps for the use of “HCI Test” program are a simple process as

detailed below.

1. HCI Test program filed called “hcitest_1.exe” can be found in CD-Rom, click on the file

to launch the program.

2. Once the program is launched, a “Communications Interface” window will be displayed,

please select the interface options “Serial Interface” or “USB Interface”, if it is an UART

interface device, please select Serial Interface and set the “Serial Port” and “Baud

Rate “ in the Serial Parameters box, then click OK. The configuration of both Master and

Slave shall be the same. (as Figure 7)