User's Manual

39
Important Information
This model must be installed and used in
strict accordance with the manufacturer’s instructions
as described in the user documentation that comes with
the product. The device complies with the following
radio frequency and safety standards.
Federal Communications Commission
(FCC) Compliance Notice
Radio Frequency Notice
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user authority to operate the equipment.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.This device may not cause harmful interference.
2.This device must accept any interference received,
including interference that may cause undesired
operation.
The users manual or instruction manual for an
intentional or unintentional radiator shall caution the
user that changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does not cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna, (2)
Increase the separation between the equipment and
receiver, (3) Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected, (4) Consult the dealer or an experienced
radio/TV technician for help.
Interference Notice
This model is a radio device that might
cause interference with other non-Bluetooth devices
(for instance, devices using wireless LAN).
802.11b technology might cause degradation
on the performance of Bluetooth
devices.
CAUTION:
1.To comply with FCC RF exposure compliance
requirements, a separation distance of at least 20 cm
must be maintained between the antenna of this device
and all persons.
2.This Transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
Department of Communications-Canada
Canadian Compliance Statement
This Class B Digital apparatus meets all the
requirements of the Canadian Interference Causing
Equipment Regulations.
Cet appareil numerique de la classe B respect les
exigencies du Reglement sur le material broilleur du
Canada.
This device complies with Class B Limits of Industry of
Canada. Operation is subject to the following two
conditions: 1) this device may not cause harmful
interference, and 2) this device must accept any
interference received, including interference that may
cause undesired operation. This device is certified to
the requirements of RSS-139-1 and RSS-210 for 2.4
GHz spread spectrum devices. The use of this device in
a system operating ether partially or completely
outdoors may require the user to obtain a license for
the system according to the Canadian regulations. For
further information, contact local Industry Canada office.
EN 55 022 Statement: CE Warning
This is to certify that the Model is shielded
against the generation of radio interference in
accordance with the application of Council Directive
89/336/EEC, Article 4a. Conformity is declared by the
application of EN55 022 Class B. This is a Class B
product. In a domestic environment, this product may
cause radio interference, in which case the user may be
required to take adequate measures.
CE Declaration of Conformity
For the following equipment: Product Name: Bluetooth
USB Dongle
Is herewith confirmed to comply with the requirements
set out in the Council Directive on the Approximation of
the Laws of the Member States relating to 1999/5/EC
R&TTE Directive. For the evaluation regarding the
Directives, the following standards were applied: ETSI
300
DECLARATION OF CONFORMITY