User's Manual

Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—94—
6.2.7.1 Discovering and Registering the PIR Motion Sensor
Follow these steps to discover and register the PIR motion sensor:
Step
Action
1.
Place the DLC into Discovery Mode in DLD.
2.
Make the PIR motion sensor discoverable by inserting the battery.
Alternate Method: Press and hold the tamper switch for two (2) seconds, then
release.
3.
Confirm that the PIR motion sensor has been discovered in DLD.
4.
Label the PIR motion sensor in DLD.
6.2.7.2 Selecting a Mounting Location
Select a location for the PIR so that an intruder will cross the beams of the
selected pattern.
Do not install the detector in areas where large metal objects might interfere with
the transmission of signal.
Choose a location that is at least 7 ½ feet and less than 8 feet above the floor to
mount the PIR.
6.2.7.3 Assembling the PIR
The PIR can be mounted to a wall or ceiling using the supplied brackets, as shown in
Figure 60.
Figure 60: PIR back cover with brackets