User's Manual

Installation and Operations Manual
AT&T Proprietary (Internal Use Only)
—62—
6.1.2.1 Installing the Siren
Install the siren by plugging the grounded plug into a single socket on a wall AC outlet as
shown in Figure 39. Then install the retaining screw into the plastic tab located at the top
of the unit to secure the unit to the AC outlet.
Figure 39: Siren
The LED shows the system status, as follows:
Solid Green—unit is AC powered and backup battery is good.
Blinking Green—unit is not AC powered and is operating on backup batteries.
Solid Red—unit is AC powered and the backup battery needs to be replaced.
Off—unit is not AC powered and backup battery has failed.
6.1.2.2 Discovering and Registering the Siren
Follow these steps to discover and register the siren:
Step
Action
1.
Place the DLC into Discovery Mode in DLD.
2.
Plug in the siren and once it has powered make it discoverable by pressing the
learn button located on the side of the unit.
3.
Confirm that the siren has been discovered in DLD.
4.
Label the siren in DLD.