Operation Manual

TECOM SOHO Department Preliminary Feature Operation for Casio 1&2-Line Cordless Phone
Issued by: Frank Yang-Hsin LIN Date: Mar. 31, 2000
Revision: 0.3 Page:10/73
III. PROGRAMMING ( HANDSET UNIT ONLY)
1. Summary of the Programming and Function Codes
1.1 Programming Codes
There are some programming parameters on the handset, and here are the operation and the list.
. Standby, the LCD displays:
R i n g : M i d
I D : 1 1
< i c o n s >
Note: 1. "Ring": Ringer volume that may be Low, Mid, Hi or DND.
2. "ID": Identification Number of the handset.
3. <icons>: Icons for the status of CO lines, and battery.
. Press [PRG] and then enter the programming items, you may press the [ s ]/[ t ] to select the item you want to change
1. System Security Code (S.S.C.)
2. Register Programming
3. Handset ID Programming.
4. CO Line Ring Programming.
5. Handset Ring Type Programming.
6. Hold-Reminder Time Programming.
7. FLASH Time Programming.
8. Tone/Pulse Mode Programming.
9. Caller ID Area Code Dialing Method Programming (Refer to the Caller ID Operation)
10. LIU (Line In Use) Enable/Disable Programming
11. Line Select Enable/Disable Programming
12. Privacy Enable/Disable Programming
13. First Line Select Programming
14. Ringer Level Programming
15. Handset RESET Programming.
1.2 Function Codes
There are some function access codes on the handset, here is the summary.
For more details, please refer to the following paragraphs.
Each time you press the [ FCN ] will form a function access key by followed function access code [ 1/4/7/* ].
. Standby, press [FCN]
R i n g : M i d
I D : 1 1

< i c o n s >
The symbol "" indicates [FCN] key prompt
[FCN] [1] DELETE code, to delete the SPEED/CID list memory, or CID area Code
[FCN] [4] DND code, to activate Do Not Disturb feature
[FCN] [7] PAUSE code, to insert a delay during digits
[FCN] [*] CONFERENCE code, to bridge 3-way conference call