Operation Manual

TECOM SOHO Department Preliminary Feature Operation for Casio 1&2-Line Cordless Phone
Issued by: Frank Yang-Hsin LIN Date: Mar. 31, 2000
Revision: 0.3 Page:18/73
IV. PROGRAMMING ( MHS-2 BASE UNIT ONLY)
1. Summary of the Programming
There are some programming parameters on the base unit, and here are the operation and the list.
. Press [PROGRAM] and then enter the programming items.
Rotate the Data Dial to select the item you want to change
1. System Security Code (S.S.C.)
2. CO Line Ring Programming.
3. Tone/Pulse Mode Programming.
4. LIU (Line In Use) Enable/Disable Programming
5. Line Select Enable/Disable Programming
6. Privacy Enable/Disable Programming
7. First Line Select Programming
8. Date/Time Programming
9. Caller ID Area Code Dialing Method Programming (Refer to the Caller ID Operation)
10. Date/Time Programming
11. Hold-Reminder Time Programming.
12. FLASH Time Programming.
13. Ring Type Programming.
14. Ringer Level Programming
15. Base RESET Programming.
2. Programming the System Security Code on the Base
. Standby, press [PROGRAM] and the LCD displays:
P r o g r a m
. Rotate the Data Dial to select the item to set the system security code
S e c u r i t y C o d e
( E m p t y )
Or
S e c u r i t y C o d e
1 2 3 4 5 6
1. Program : Programming start prompt
2. Security Code : Security Code programming mode prompt
3. (Empty) : Security Code is not programmed
4. 123456 : The Security Code already exists.
. Press the center of the Data Dial to select this item,
. Enter [ 1/2/3/4/5/6/7/8/9/0/*/#/PAUSE/FLASH ] 6 digits for new S.S.Code, say 775141. The LCD will display:
S e c u r i t y C o d e
7 7 5 1 4 1
. Press the center of Data Dial to accept the new security code.
3. CO Line Ring Programming
You may program each the CO line incoming call will ring or not on your handset. Default all the 2 CO lines will ring.
. Standby, press [PROGRAM]