User Manual

15
FCC statements
Notice: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device generates and radiates radio-frequency energy. In order to comply with FCC
radiofrequency radiation exposure guidelines for an uncontrolled environment, this equipment
has to be installed and operated while maintaining a minimum body to antenna distance of
20cm. The antenna(s) used for this transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
This product does not contain any user serviceable components. Any unauthorized product
changes or modifications will invalidate warranty and all applicable regulatory certifications
and approvals.
This equipment has been tested and found to comply with the limits for a Class B Digital
Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio / TV technician for help.
FCC OEM Labeling instructions:
OEM should add following label:
Contains FCC ID: D6XWL5011S
Above should be clearly visible on products where WL5011s modules are installed.