User's Manual

configuration pages. Leave this field and Router Password blank to disable access

control.

Router Password:

Sets the password for access to these configuration pages.

Leave this field and

Router Username

blank to disable access control.

Router WAN

Port: Sets the WAN port to use the remote access to these configuration pages. Leave

this field blank to disable remote access.Router Mode: Router Mode is default. If you

select

Access Point Mode

that is disabling

LAN DHCP Server

LAN Spanning Tree

Protocol

, and

WAN Protocol

Firewall:

Sets whether the firewall should be disabled.

Connections form the WAN are allowed if the Firewall is disabled.

Note

If your ISP has provided the DHCP functionality, you should select the Router

Mode. The capability of Access Point Mode is similar to the single Hub, and

doesn’t support the DHCP function.

The other relative setting:

1. Time Zone: Sets the Time Zone of this locale.

2. NTP Server: Sets the IP address of the NTP Server to use for time synchronization.

3. Syslog IP Address: System log message will be sent to this IP address.

4. UPnP : Sets whether UniversalPlug and Play (UPnP) is enabled.

5. Connection Logging: Sets which connections through the router should be logged.

Selecting Denied enables logging of denied connections. Selecting Accepted enables logging

of accepted connections. Select Both enables logging of both denied and accepted

connections.

Figure 9. Basic Screen (4)