Installation Guide
The Mosack Group, Inc.
Mint Hill, NC 28227
1.888.229.2874
www.apolloow.com
is-FSBBOXWM_09/20/2021
INSTRUCTION SHEET
Push-To-Connect
Washing Machine Outlet Box
PUSH TO CONNECT
FSBBOXWM/FSBBOXWMWH
Installation Instructions:
1. Turn o and fully drain water supply to involved piping.
2. Attach brackets to the studs making sure the outlet box can attach to the brackets on both sides.
3. Connect the cold water line to the Tectite by Apollo Push-To-Connect valve with the blue handle. Connect the hot water line to the
Tectite by Apollo Push-To-Connect valve with the red handle.
4. Secure water lines into place to prevent movement.
5. After sheet rock is installed and painted, press faceplate into place.
6. Attach the supply lines to the valves and attach to the washing machine.
7. Turn on water supply. Check valves and hoses for leaks.
To Change Valve Conguration:
Tools Required: 8mm hex key & crescent wrench
1. Using a crescent wrench, hold the valve body in place at the base of the inside of the appliance box.
2. Insert an 8mm hex key into the Tectite by Apollo push-to-connect tting until it seats properly and turn counter-clockwise completely removing
the tting from the valve body.
3. Remove the slim retaining nut which will allow for the removal of the valve body.
4. Turning the box 180º so the top becomes the bottom will reveal knockouts for a side oriented drain and the appropriate valve placement
locations.
5. Insert the valves, tighten the retaining nut and push ttings back into place. The integrated o-ring design eliminates the need for the use
of thread tape or sealant.
Removal tool
(sold separately).
Place tool around
pipe next to
fitting. Press tool
toward fitting
while pulling pipe
from fitting.
Push Installation
Mark insertion
depth using the
depth gauge
(sold separately).
2
Push pipe (A) and
twist (B) into fitting
until fitting edge
meets depth line.
3
Cut pipe.
1
Push Removal
Removal tool
(sold separately).
Place tool around
pipe next to
fitting. Press tool
toward fitting
while pulling pipe
from fitting.
Push Installation
Mark insertion
depth using the
depth gauge
(sold separately).
2
Push pipe (A) and
twist (B) into fitting
until fitting edge
meets depth line.
3
Cut pipe.
1
Push Removal
Pipe Depth for Tectite Fittings
Fitting/Pipe Size Insertion Depth
1" 1-5/16"
3/4" 1-1/8"
1/2" 15/16"
3/8" 15/16"