Operation Manual

Regulating air flow direction
Press the SWING switch to position " I ", the vertical louvers will swing from side to side for even air
distribution. The horizontal louvers must be adjusted by hand.
F DRAINAGE
During the process of cooling, some water will be extracted from the air into the unit. If the reservoir is full,
the compressor will stop, only the fan to circulate the air. The ‘”FULL WATER” indicator will light now to
remind you. To make the cooling work again, please empty the water by one of the following ways:
By water tray
Turn off the unit. Unplug the unit from the electrical outlet.
Grasp the attached handle, pull the water tank slightly up and then pull lightly out for easy removal.
Empty the tank.
Push the water tank back into place.
Reset the unit to desired functions as previous description to continue normal operation.
5
4
3
2
1
NOTICE!
G
1. To prolong the compressor's life, after switch-off of the unit, please wait for 3 minutes
(at least) before re-switch.
2. The cooling system will switch off if the ambient temperature is lower than the set one.
The ventilation, however, keeps working on the set level. If the ambient temperature rises
above the selected level, the cooling will return to work.
3. On the contrary, the heating will switch off if the ambient temperature is higher than the
set one (still, the ventilation keeps working on the set level). As the ambient temperature
drops below the selected level, the heating will return to work.
4. This machine is equipped with ANTI-FROST function. While using the heating function
during low temperature, sometimes the heating will stop for a while in order to melt the
frost. As this occurs, just wait for the heating returns to work.
1
4
58