Operation Manual

C
ONNECTING
Pass the connection tube through the hole (at least Ø 50 mm) in the wall.
Remove the protection caps from the ends of the refrigerant tubes.
Reconnect the refrigerant tubes according to the marking (tighten the nuts
quickly to make a good seal), the drain tube and the electrical cable.
Put the isolation material around the connectors / tubing again.
Put back the metal brackets which are holding the tubes and wire.
Close the cabinet cover for quick connector shielding
L.
Store the protection caps
R in a safe place.
H CLEANING
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions. For maintenance of the filters, refer to
Chapter D “Air Filter”.
G
NOTE!
Never use the air conditioner without screenfilter.
G
WARNING!
Switch off the unit and remove the plug from the mains before cleaning
the appliance or filter, or before replacing the filters.
G
WARNING
After connecting the refrigerant tubes, take care that these are well
isolated again. If this is not done properly, damage because of
condensation water can occur!
7
6
5
4
3
2
1
4
60