Owner's manual

TECHNOLOGIES 834 Sprayer Control
98-70019-R1 -4-
Start
To begin the programming process:
☛ Read above for programming tips.
☛ Be sure the Master boom switch is “OFF.”
☛ Turn console “ON” by pressing the key. When the control console is turned on, the
software version will be displayed for approximately 5 seconds. At the same time all LED’s
will be ON.
The software version and serial number of the console will be needed when calling for
service support. The serial number is located on a sticker on the back of the console.
Example: the software version is L2.12.
☛ After a short time the console will change to the target application rate display.
CAL D
I
3 sec. = Pro
L2.12
CAL D
I
3 sec. = Pro
T 50