User Manual

MI 834 Programming and Operating Manual 9/99 Page 7 of 15

Radar

A radar speed sensor will be indicated with an "r" on

the display e.g.

The "r" will automatically appear during the auto

calibration process when the console has determined

that a radar is being used. When manually entering

a radar calibration number the "r" must be turned on

by pushing the Auto/Man key. With this key you can

toggle between radar or wheel sensor. The calibration

value itself is adjusted with the

and

keys.

Manual Calculation

To manually calculate the proper value for Wheel Speed Sensor pulses, you need to know the

circumference of the wheel to which the sensor is mounted. It can be measured by marking the

tire and measuring the distance covered as that mark makes one full revolution.

Then use the following formula:

248

4600,3

#600,3

InchInnceCircumfereWheel

WheelOnMagnets

Use the

or keys to adjust the value. Press the key to validate the value and

advance to the next programming step.

Note: The wheel calibration should be repeated if you are changing to another wheel diameter.

Simulated Speed

If you enter 0 in the speed calibration step, then the console always works with a simulated

speed. This simulated speed can be used to test out the sprayer at stand still.

The simulated speed feature allows you to check out the sprayer at a certain speed without

actually moving the sprayer. This can be done prior to any spraying activity. The simulated speed

value can be changed with the

and keys when the speed is shown on the display in

normal working mode.

Tip

select

GPA

MPH

PSI

tip spacing

(inch)

speed cal

(pulses/300ft.)

PROGRAM MODE push 3 sec.

density

r10.0