User Manual

20
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Implement Setup
When a SmartCable or Section Driver Module (SDM) is not present
only a single boom setup is available. Congurations for Overlap,
Delay On and Delay Off will not be available, and Number of
Sections will be set to one.
1. Press CONFIGURATION side tab .
2. Press
Implement .
3. Select from:
►Number of Boom Sections
#
– establishes the number of
boom sections
►Guidance Width – establishes the width between
guidelines
►Spray Width – establishes the width of each boom
section for a total spray width
►Overlap
– determines the amount of overlap allowed
►Delay On
– establishes the timing for the boom section
valves to switch on
►Delay Off – establishes the timing for the boom section
valves to switch off
4. Press RETURN arrow or CONFIGURATION side tab to
return to the main Conguration screen.
NOTE: Press or to switch between Implement setup screens.
Figure 3-15: Implement Setup Options
Conguration
Vehicle
Implement
AutoSteer
Tilt
Lightbar
GPS
Video
Cong->Implement
Num Sections
Spray Width
Guidance Width
60.00 ft
144.00 ft
15
Cong->Implement (2)
Overlap
Delay O
Delay On
1.00 s
1.00 s
50%