User Manual Owner manual

98-05239 R1 EN

HOME OVERVIEWSETUP POWERAPPENDIX FULL SCREEN INTRODUCTIONGUIDANCE

Implement - SmartCable or SDM

Implement Setup is used to establish number of boom sections, guidance width, spray width, overlap percentage, implement delay on

time and implement delay off time.

Note: If a SmartCable or Section Driver Module (SDM) is not present the configurations for Number of Boom Sections, Overlap, Delay

On and Delay Off will not be available - only Guidance Width and Spray Width can be entered. Please refer to Single Boom

Setup to view setup steps.

1. Press CONFIGURATION side tab .

2. Press

Implement .

3. Select from:

►Number of Boom Sections

– used to select the number of available boom sections

►Guidance Width – used to enter the width between the guidelines

►Spray Width – used to enter the width of each implement section

►Overlap

– used to select the amount of overlap allowed when the boom sections are turned on and off

►Delay On

– used to enter the timing for the boom section valves to switch on

►Delay Off

– used to enter the timing for the boom section valves to switch off

4. Press RETURN arrow

or CONFIGURATION side tab to return to the main Conguration screen.

NOTE: Press or to switch between Implement setup screens.

Figure 6-12: Implement Setup Options with SmartCable or SDM

Conguration

Vehicle

Implement

AutoSteer

Tilt

Lightbar

GPS

Video

Cong->Implement

Num Sections

Spray Width

Guidance Width

20.00 m

21.00 m

Cong->Implement (2)

Overlap

Delay O

Delay On

1.00 s

50%