User Manual Owner manual

40
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Implement - Single Boom Setup
Implement Setup for a single boom is used to establish guidance
width and spray width.
Note: If a SmartCable or Section Driver Module (SDM) is present
the configurations for Number of Boom Sections, Overlap,
Delay On and Delay Off will be available. Please refer to
the Implement - SmartCable or SDM section to view setup
steps.
1. Press CONFIGURATION side tab .
2. Press
Implement .
3. Select from:
►Guidance Width
– used to enter the width between the
guidelines
►Spray Width – used to enter the width of the implement
4. Press RETURN arrow or CONFIGURATION side tab
to return to the main Conguration screen.
Figure 6-19: Implement Setup Options with No SDM
Conguration
Vehicle
Implement
AutoSteer
Tilt
Lightbar
GPS
Video
Cong->Implement
Num Sections
Spray Width
Guidance Width
20.00 m
21.00 m
1
Guidance Width
Guidance Width establishes the width between the guidelines.
Range is 1.0 - 75.0 metres.
1. Press the KEYPAD icon .
2. Use the entry screen to establish the guidance width.
NOTE: This setting is required for auto steering and tilt sensor
operation.
Figure 6-20: Guidance Width
Cong->Implement
Num Sections
Spray Width
Guidance Width
20.00 m
12.00 ft
1
Guidance Width (m)
1 2 3
20.00
Clear
4 5 6 <--
7 8 9
0 .
+/-
Spray Width
Spray Width establishes the width of the implement.
Range is 1.0 - 75.0 metres.
1. Press the KEYPAD icon .
2. Use the entry screen to establish the spray width.
NOTE: This setting is required for auto steering and tilt sensor
operation.
Figure 6-21: Spray Width
Cong->Implement
Num Sections
Spray Width
Guidance Width
20.00 m
21.00 m
1
Section 1 Width (in)
1 2 3
21.00
Clear
4 5 6 <--
7 8 9
0 .
+/-