User Manual Owner manual

50
www.teejet.com
HOMEOVERVIEW SETUP POWER APPENDIXFULL SCREENINTRODUCTION GUIDANCE
Options: Steering Wheel Sensor
Steering wheel sensor selects whether the sensor used to
automatically disengage FieldPilot is magnetic or pressure
based when the steering wheel is turned. Check your specic
conguration to determine if a Steering Wheel Switch Kit or a
Pressure Sensor is being used.
The UniPilot is not affected by this setting.
1. Select Options .
2. Press DOWN arrow to access the list of options.
3. Select:
►Magnetic
►Pressure
Figure 6-39: Options: Steering Wheel Sensor
Cong-> AutoSteer
Enabled
Valve Setup
Steering Settings
Valve Test
Valve Diagnostics
Angle SensorOptions
On
Cong-> AutoSteer->Options
Steering Wheel Sensor
Magnetic
Magnetic
Pressure
Angle Sensor
Angle Sensor is used to establish the Steering Angle Sensor
(SAS) as the primary feedback sensor for auto steering, calibrate
the SAS and set an offset adjustment.
1. Select Angle Sensor .
2. Select if the angle sensor is
►Enabled
►Disabled.
3. Select from:
►Calibrate Sensor – sets the turn rate when steering the
vehicle left and right.
►Offset Adjustment – adjusts the path of travel to the
established guideline.
Figure 6-40: Steering Angle Sensor
Cong-> AutoSteer
Enabled
Valve Setup
Steering Settings
Valve Test
Valve Diagnostics
Angle SensorOptions
On
Cong-> AutoSteer->Angle Sensor
Angle Sensor
Calibrate Sensor
Oset Adjustment
Enabled