User Manual Owner manual

57
98-05239 R1 EN
HOME OVERVIEWSETUP POWERAPPENDIX FULL SCREEN INTRODUCTIONGUIDANCE
GPS
GPS is used to congure GPS Type and GPS Port.
NOTE: These settings are required for assisted/auto steering
and tilt sensor operation, as well as proper implement
operation.
1. Press CONFIGURATION side tab .
2. Press
GPS .
3. Select from:
►GPS Type
– select GPS source transmissions
►GPS Port – sets (D)GPS COM port
►GPS Status – displays information for TeeJet Customer
Service use on GGA/VTG (Data Rates), Number of
Satellites, HDOP, PRN, GGA Quality, GPS Receiver and
Receiver Version
4. Press RETURN arrow
or CONFIGURATION side tab
to return to the main Conguration screen.
Figure 6-53: GPS
Conguration
Vehicle
Implement
AutoSteer
Tilt
Lightbar
GPS
Video
Cong->GPS
GPS Status
GPS Port
GPS Type
Information
Internal
GPS/DGPS
GPS Type
GPS Type customizes the system to accept GPS source or
DGPS source transmissions. GLONASS is only available with a
compatible receiver.
1. Press DOWN arrow to access the list of options.
2. Select:
►GPS Only – uncorrected signals
►DGPS Only – differentially corrected signals
►GPS/DGPS – either type of signal
►GPS+GLONASS – uncorrected signals from both the GPS
and GLONASS systems
Figure 6-54: GPS Type
Cong->GPS
GPS Status
GPS Port
GPS Type
Information
Internal
GPS/DGPS
GPS Only
DGPS Only
GPS/DGPS
GPS+GLONASS
GPS Port
GPS Port sets port transmission to Internal or External.
1. Press DOWN arrow to access the list of options.
2. Select:
►Internal – use the internal (D)GPS (if equipped) and
transmit out
►External – receive external (D)GPS data
NOTE: Working with GPS signals such as OmniStar HP/XP or
RTK will require GPS port to be set to External.
Figure 6-55: GPS Port
Cong->GPS
GPS Status
GPS Port
GPS Type
Information
GPS/DGPS
Internal
Internal
External