RX375p I n s ta l l at i o n M AN U AL
Copyrights © 2013 TeeJet Technologies. All rights reserved. No part of this document or the computer programs described in it may be reproduced, copied, photocopied, translated, or reduced in any form or by any means, electronic or machine readable, recording or otherwise, without prior written consent from TeeJet Technologies. Trademarks Unless otherwise noted, all other brand or product names are trademarks or registered trademarks of their respective companies or organizations.
RX375P Table of Contents Chapter 1 INTRODUCTION features 2 2 LED.................................................................................................................................................................................................2 Radar-Simulated Pulse Output.......................................................................................................................................................2 CAN..................................................................
RX375P Chapter 1 INTRODUCTION The RX375P is a smart antenna that tracks GPS and SBAS (WAAS, EGNOS, and MSAS) signals. The RX375P provides sub-meter performance with 2.0 ft (60 cm) accuracy 95% of the time. It utilizes COASTTM technology during differential outages. The RX375P is also capable of using e-Dif® and L-Dif® technology. features The RX375P has several features that will enhance the product’s performance.
RX375P Components Unpack the installation kit and identify the required parts for your installation. Item Part Number Description Quantity A 78-50203 Receiver, RX375P, SBAS.................................................................................................................................................1 B Magnet Mount Adapter, RX375P......................................................................................................................................
RX375P Item Part # Description Illustration GPS NMEA Data D* 45-05340 0 534 45-0 xx/xx : DC Cable, Deutsch to DB9 Power Power D* 45-05350 Cable, Com 1 & 2 with Power In Port A 4800 GGA 5Hz VTG 1Hz 45-05350 DC: xx/xx Port B 19200 GGA 5Hz VTG 1Hz * Depends on which cable was ordered with the receiver Cables The following figure provides a front view of the Deutsch connector receptacle’s numbering.
RX375P Mounting RX375P Placement Placement of the RX375P is crucial to the system’s operation. The GPS engine inside the RX375P computes a position based upon measurements from each satellite to the internal GPS antenna unit. Mount the RX375P to the identified point of interest. When choosing a location, make certain there is an unobstructed view of the sky available to the smart antenna.
RX375P Powering the RX375P Connect the RX375P to a TeeJet Technologies guidance system or a 12 volt DC source with a power connector. Refer to Appendix D for illustrations. Choosing the appropriate connector will depend on specific installation requirements. NOTE: It is recommended that a weather-tight connection and connector be used if the connection will be located outside. arning! Be careful not to provide a voltage higher than W the input range. This will damage the antenna.
RX375P Chapter 3 GPS Overview Table 5: Serial Port Settings Serial Port Baud Rate Data Bits Parity Stop Bits Interface Level 4800* 8 None 1 R2-232C 9600 8 None 1 R2-232C 8 None 1 R2-232C 8 None 1 R2-232C 57600 8 None 1 R2-232C 115200 8 None 1 R2-232C Serial Port 19200** A and B 38400 For operator convenience, both the GPS and differential correction of the RX375P are pre-configured.
RX375P Differential Operation The Radio Technical Commission of Marine services (RTCM) has a differential service intended for correction services. This includes the Space Based Augmentation Systems (SBAS), such as the Wide Area Augmentation System (WAAS) and the European Geo-stationary Navigation Overlay System (EGNOS). The RX375P is compatible with each of these differential services in addition to e-Dif.
RX375P APPENDIX B - SPECIFICATIONS Table 11: Environmental Specifications The following tables provide the power, mechanical, communication, environmental and DGPS specifications for the RX375P.
RX375P APPENDIX C - SURFACE MOUNT TEMPLATE The following templates should be used to plan for the location of the mounting holes when surface mounting the RX375P. Use to mark holes from INSIDE the cab WARNING! Print this page at 100% Use to mark holes from OUTSIDE the cab 10 www.teejet.
RX375P APPENDIX D - ILLUSTRATIONS Table 14: CenterLine with SmartPad II with RX375P System Configuration SmartPad II 75-30005 SmartPad II/CL Lightbar Cable 45-05427 Cable, Power 45-05324 45-05338 Smart Pad II 45-05324 RX375p Receiver 78-50203 CenterLine CenterLine Lightbar 78-50111 Receicer 45-05337 5 Amp Status Detect IGN Sense Power In +12 v 78-00027 Warning 45-05298 Cable, GPS Data 45-05338 Switchbox Ignition On/Off 78-00027 (Optional) Cable, 2 Position Battery 45-05298 98-05327-ENUS
RX375P Figure 4: Standard CenterLine System Configuration with RX375P CenterLine Lightbar 78-50111 RX375p Receiver 78-50203 45-05338 45-05324 CL Wireless Remote 78-50107 Cable, Power 45-05324 Cable, GPS Data 45-05338 5 Amp Status Detect IGN Sense Power In +12 v Warning 45-05298 78-00027 Cable, 2 Position Battery 45-05298 12 www.teejet.
RX375P Figure 5: FieldPilot Assisted Steering with RX375P System Configuration Legacy 6000 Console 75-05007 Lightbar 78-50140 Legacy 6000 Harness 45-07000 CAN Term. Male 45-08101 CAN CAN Extension Cable 6’/1.8m 45-08106 CAN Term.
R x 3 7 5 p I n s ta l l at i o n M a n u a l The RX375P is a smart antenna that tracks GPS and SBAS (WAAS and EGNOS) signals. The RX375P provides sub-meter performance with 2.0 ft (60 cm) accuracy 95% of the time. It utilizes COASTTM technology during differential outages. The RX375P is also capable of using e-Dif® and L-Dif® technology. 1801 Business Park Drive Springfield, Illinois 62703 USA Tel: (800) 643-8324 • Fax: (800) 230-6211 www.teejet.
