User Guide
8
QUICK START
The setting of the TMCT-10 Barcode Scanner can be changed by reading the setup
barcodes contained in this manual. This section describes the procedure of setting the
TMCT-10 Barcode Scanner by reading the setup barcodes and provides some example
for demonstration.
Steps Action Feedback if Successful
1 Turn on TMCT-10 Barcode Scanner... It will response with a long beep
(high tone), it's LED shows red and
with Intmt twinkle.
Note: How the TMCT-10 Barcode Scanner establishes a connection with computer or
other compatible device, please refer to Chapter 2.
2 Enter the Setting Mode... The TMCT-10 Barcode Scanner will
response three beeps (tone descending
from high to low), and its LED indicator
will flashing purple.
3 Read a Setup barcode The TMCT-10 Barcode Scanner will
response three beeps (tone ascending
from low to high), and its LED indicator
will flashing purple.
For Example:
4 Exit the Setting Mode... The TMCT-10 Barcode Scanner will
response three beeps (tone descending
from high to low), and its LED indicator
will not flashing purple and power off.
Note: When any setup error occurs, the TMCT-10 Barcode Scanner will respond with a
long beep (low tone), and its LED indicator will flashing purple.
Enter Setup
Enable Codabar
Exit with Save