User Manual
EN
Owner’s manual28
5. Close the cover.
6. Press the button corresponding to the number of coee required.
7. Device starts coee preparation.
Hot water
1. Make sure the water tank is lled with fresh water.
2. Attach the desired accessory (frothing nozzle or 3-step milk frother) to the hot water/steam spout.
3. Place a cup under the spout.
4. When the device is in Ready status (READY), turn the hot water/steam knob switch to the
position.
5. Water starts to ow from the spout.
6. Use the Adjustment knob to set water quantity. Range of water quantity is from 30 to 480 ml.
Rotate the Adjustment knob until desired water quantity appears on the display.
• If the water quantity is not adjusted, the device will use last setting.
Danger of scalding!
• Take special care in the initial process of hot water delivery, as splashes of hot water may be
released and become the cause of scald.
• Do not remove the nozzle directly after hot water delivery, as it is hot! Let it cool down for a
while and then remove it.
7. When the preset water quantity is reached, the device stops delivering water. CLOSE TAP appears
on the display. Set the hot water/steam knob switch back to the
position.
8. It is possible to stop water delivering manually. Set the hot water/steam knob switch back to the
position when the desired water quantity is reached.
Steam
Caution! Danger of scalding! Small jets of water may come out of the spout. The spout can
become hot- do not touch it directly with bare hands!
1. Attach the 3-step milk frother to the hot water/steam spout.
Important! Make sure it is connected tightly to the hot water/steam spout, otherwise it may
suddenly come o during operation!
2. Attach the milk pipe to the 3-step milk frother.
3. Immerse the other end of the milk pipe in a container lled with cold milk or directly into the milk package.
4. Place a cup under the milk frother.
5. Press the Steam function button.
6. Wait until STEAM READY appears on the display and turn the hot water/steam knob switch to the
position. Frothing process begins.
Notes:
• Before the actual frothing process, some water may come out of the milk frother, but it does
not have negative impact on the process and nal result of milk frothing.
• The coee machine is ready to generate steam as long as STEAM READY is displayed.
• To switch between hot water and steam function, press the Steam function button again.
7. Use the Adjustment knob to set the steaming time from 3 to 120 seconds.
• If the steaming time is not adjusted, the device will use last setting.
8. Set the switch of the 3-step milk frother to the desired position:
• turn the switch upwards to heat and froth milk.