Instruction Manual

FIGURE 4

CONSOLE ASSEMBLY

Figure 27

Figure 28

Figure 29

IMPORTANT: The batteries can be installed and replaced without removing the console. However, for

easier access, we recommend inserting the batteries before installing the console. Open the Battery

Compartment located on the back of the console. Ensure that the battery contacts and compartment are

clean. Locate the 2 × included batteries (AA 1.5 V Alkaline) and install them in the back of the Console in the

Battery Compartment, noting (+) and (-) symbols.

Step 13 Hardware Kit

IMPORTANT: Use caution to ensure the Sensor

Wire on the Console does not get pinched or

pulled during assembly.

Figure 27: Guide the Sensor Wire through the

opening in the Console Support while aligning

the Console.

Figure 28: Use the Step 13 Hardware Kit

to attach the Console.

Hand tighten 4 × Bolts through the Console

and into the Console Support.

Proceed to fully tighten all 4 × Bolts with

the Phillips Screwdriver.

Figure 29: Connect the Console Cables by

snapping together the two ends of the

Cables.