User Manual

STEP 1

Assemble A-Frame Base & Stretch Assist Handles

(X1 Models)

• On a level surface, position the A-Frame so that it is standing upright

and the Stability Feet are on the ground.

• Gently push down on the Spreader Arms to ensure they are fully open

and in the “locked” position (Figure 1).

• Look for temporary circular assembly assistance labels on the

A-Frame. RIGHT, LEFT, FRONT, and REAR indicate your position while

using the equipment, not facing it. These labels can be removed easily

upon completion of assembly.

• Locate the Handle Assembly Hardware Kit (HK1008).

• Determine the left or right handles, marked with an embossed L / R

on the inside of the black plastic part of each handle.

• Align the black plastic part of the corresponding handle (left / right)

over the outside edge of the Hinge Plate on the A-Frame (Figure 2).

• Insert and loosely hand-tighten three of the Allen Head Screws

through the Hinge Plate into the handle (Figure 3).

• Repeat with other handle. Tighten all fasteners with the

5mm Allen Wrench provided, being careful not to over-tighten.

• Proceed to Page 8 for Step 2.

1 - Spreader Arms 2 - Crossbar

LEFT

RIGHT

FIGURE 1

REAR

FRONT

For X1 Models

FIGURE 2

FIGURE 3

LOCKED

FIGURE 1a

UNLOCKED