800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page1 EN www.tefal.
1800135249 FV53XX Z0.
1800135249 FV53XX Z0.
1800135249 FV53XX Z0.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page5 EN Important safety recommendations • Please read these instructions carefully before first use. This product has been designed for domestic and indoor use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply. • Never unplug the appliance by pulling the power cord.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page6 appliance, once it is unplugged, please wait until it has cooled down (around 1 hour). • Children should be supervised to ensure they do not play with the appliance.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page7 • For your safety, this appliance conforms to all applicable regulations (Low Voltage Directive, Electromagnetic Compatibility, Environment, etc). • Your steam iron is an electrical appliance: it must be used under normal conditions of use. It is designed for domestic use only. • Always plug your steam iron: - into a mains circuit with voltage between 220 V and 240 V, - into an earthed electrical socket.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page8 • Your appliance has been designed to operate using untreated tap water. However, it is necessary to operate the Self-Clean function regularly in order to eliminate hard water deposits from the steam chamber. • Never use water containing additives (starch, scents, softeners, etc.), or water produced by condensation (e.g. water from tumble-driers, refrigerators, air conditioners, rain water).
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page9 • Set the thermostat control to “MAX” – fig.8. • Operate the Power zone trigger by pulsing – fig.7 moving the iron from top to bottom – fig.9. Dry ironing • Set the temperature for the fabric to be ironed. • Set the steam control to – fig.1. • You may start ironing when the thermostat light goes out. Extra Functions Autoclean Catalys® Soleplate (depending on model) • Your iron is equipped with a self-cleaning soleplate which works by catalysis.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page10 • Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate – fig.16. • At the end of the operation, replace the anti-scale valve; press it in until it clicks – fig.15. • Plug the iron back in and leave it resting on its heel for two minutes to dry the soleplate. • Clean the soleplate with a damp, non-metallic cloth while it is still warm.
1800135249 FV53XX Z0.qxp_110x154 09/04/15 09:58 Page11 If there is a problem PROBLEM POSSIBLE CAUSES SOLUTIONS Water drips from the holes in the soleplate. The chosen temperature is too low and does not allow for the formation of steam. Position the thermostat in the steam range (from •• to MAX). You are using steam while the iron is not hot enough. Wait until the thermostat light goes out. You are using the Power zone often. Wait a few seconds between each use of the Power zone button.
1800135249 FV53XX Z0.
