UltimateAutoclean_GB.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 fig.1 fig.2 fig.3 fig.4 fig.5 fig.6 fig.7 fig.8 fig.9 fig.10 fig.11 fig.12 fig.13 fig.14 fig.15 fig.16 fig.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 Page 3 For your safety This appliance complies with the technical rules and standards for safety currently in force (Electromagnetic Compatibility, Low Voltage, Environnement). • Please read these instructions carefully and keep them for future reference.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 Page 4 Before using for the first time Warning ! Remove any labels from the soleplate before heating up the iron (depending on model). Warning! Before using your iron with the steam function for the first time, we recommend that you operate it in a horizontal position for a few moments, away from your linen, i.e. press the Shot of Steam button a few times. During the first few uses, a harmless odour and a small amount of smoke may be given off.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 • To select the appropriate ironing programme, activate the thermostat located under the handle - fig. 5. - Rotation left : selects the programs requiring low temperature and steam levels. - Rotation right : selects the programs requiring high temperature and steam levels. - The program selected appears automatically on the indicator panel at the front of the iron - fig. 6. - Set the steam control to STEAM - fig. 1.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 8. Auto-Stop safety feature (depending on model) - For your safety, the electronic system cuts off the power and the autostop indicator light flashes - fig. 13 when : • The iron remains motionless for more than 8 minutes on its heel. • The iron remains flat or on its side for more than 30 seconds. - To restart the iron, just move it gently until the warning light stops flashing.
UltimateAutoclean_GB.qxd:TEFAL193 27/05/08 9:07 - Shake the iron gently, over the sink, until some of the water in the water tank (with the impurities) has flowed out through the soleplate. - At the end of the operation, push the anti-calc valve back into position. - Turn the iron back on for 2 minutes, setting it on its heel, to dry the soleplate. - Unplug the iron, and when the soleplate is just warm, wipe it with a soft cloth. 2.
27/05/08 9:07 Page 8 • The soleplate is dirty or brown and can stain the linen. • You have ironed with an unsuitable programme (temperature too high). • You are using starch. • Select the appropriate program. Refer to the chapter “Clean the soleplate“ • Spray starch on the underside of the fabric to be ironed. • There is little or no steam. • The water tank is empty. • The anti-calc valve is dirty. • Your iron has a build-up of scale. • Your iron has been used dry for too long. • Fill it.