Operating Instructions

- Do not cut or attempt to extend the steaming hose.
- To prevent the appliance over heating, when you hang clothes on garment hook for
removing crease, please assemble the attached garment telescopic handle and extend it
to its highest position.
Environmental protection first !
i Your appliance contains valuable materials which can be re-
covered or recycled.
‹ When disposing of it, take it to a local civic waste collection point.
DESCRIPTION
GARMENT STEAMER ASSEMBLY
Telescopic handle and hanger assembly
1. Unscrew the handle's fastening screw on the base of the handle. (fig. 1)
2. Hold the handle such that the cord holder is on the left. Check that the 2 handle clips
are unlocked. (fig. 2)
3. Insert the handle into the base by pressing downwards until the holes of the handle and
base are at the same level, so that you can put the screw back. If the holes are not ali-
gned, check that the clips of the handle are well and truly unlocked. (fig. 3)
4. Screw the handle fastening screw back in as far as it will go so that the handle is firmly
fixed to the base. (fig. 4)
5. Push the hanger on the top of the handle vertically until you hear a click. (fig. 5)
6. Adjust the handle to the height required by sliding it upwards then locking the 2 clips.
(fig. 6a, 6b)
7. Install the steam head between the hanger hooks.
Filling the water tank
• Ensure that the steamer is unplugged. Remove the water tank from the base of the ap-
pliance by pulling the handle upwards (fig. 7). Unscrew the tank cap and fill the tank. (fig.
8). Maximum capacity is indicated by the “max” mark.
• The steamer must be used with TAP WATER. If the water in your area is hard, we re-
commends that you mix half tap water and half distilled water, which reduces the hard-
ness. You can also use bottled spring water.
IMPORTANT: Never use water that contains additives (starch, perfume, aromatic subs-
tances, softener, etc) in the steamer. Additives such as these can affect the proper-
ties of the steam and lead to the formation of deposits.
1. Steam head
2. Steam head hook
3. Built in hanger
4. Trouser/dress clips
5. Hanger holder
6. Handle locking clips
7. Electric cord holder
8. Electric cord
9. Velcro strip
10. Telescopic handle
11. Handle fastening screw
12. Steam hose connector
13. Removable water tank
14. ON/OFF pedal
15. Transport wheels
16. Textile steam hose
17. On/ off light
18. Built in accessories
a. Fabric brush
b. Crease attachment
c. Lint pad
2
1800125996 IS6200 Z1_110X154 06/04/12 13:24 Page2