Instruction Manual

ENG
Never place the stone on the heating element if it is already hot.
Only use the stone provided with the appliance or purchased from an approved
service centre, and only on the support for which it was designed.
Never insert aluminium foil or any other object under the stone or between the
heating element and the reflector.
Connection and pre-heating
For the Ovation model: never heat the product without it being attached to
the wooden base.
Unwind the cord completely.
Connect the cord on the appliance (depending on model) then
plug into the wall socket.
Be careful about positioning the cord, so that it does not get
in the way of guests moving around the table.
Check that your electric supply is compatible with the power and the voltage
indicated under the appliance.
Connect the appliance to a plug with an earth connection, according to the model.
Models with fixed cord : if the power supply cord is damaged, it must be
replaced by the manufacturer or its service agent or a similarly qualified person
in order to avoid a hazard.
Never leave the appliance plugged in when not in use.
Do not leave the appliance switched on while unattended.
• Models with on/off switch :
Turn the switch to the “on” position: the indicator will light up.
• Models with adjustable thermostat :
Set the thermostat to the max position.
• Other models :
The appliance works once plugged into the wall socket.
During the first 10 uses, pour a little cooking oil on the stone after pre-heating and
then wipe with an absorbent kitchen towel.
This coating helps to prevent food from sticking to the stone during the first 10 uses.
For the Ovation model with thermostat:
The thermostat is located under the wooden
handle on the side of the appliance.
RaclGrCrPier T-Fal 07-06 25/07/06 9:58 Page 6