User manual

Vertical steam function (depending on model)
This is ideal for removing wrinkles in delicate garments, jackets, skirts,
curtains, etc.:
• Hang the garment on a hanger and hold the fabric slightly taut with
one hand.
Every fifth time you press the
button, return the iron to the
horizontal position.
4
Use
• Unplug your iron before filling it and set the steam control lever to
(
fig.1).
• Open the water tank filling inlet lid (
fig.2), place the iron in a horizontal
position and fill it with water (
fig.3).
• Close the water tank filling inlet lid.
Filling the water tank
Do not exceed the “MAX” fill
level as indicated on the water
tank of the iron.
• Adjust the temperature (see table below) by turning the temperature
control dial to the temperature select position (
fig. 4).
• When the iron is plugged in, the temperature control light will remain
“on” until the temperature is reached. Once the temperature is reached,
it will go “off” (
fig.5).
• Adjust the amount of continuous steam output by moving the steam
control lever (
fig.6). See below table for recommended steam output
levels.
Adjusting the temperature and the steam
- It is normal for the
temperature indicator light to
turn on and off during ironing.
- In order to avoid water leaking
from the soleplate onto your
garment:
• Set the steam lever to
when ironing silk or synthetic
fabrics and set it to for
wool.
• Should you need to turn
down the temperature, wait
until the temperature light
comes back on before
beginning to iron again.
- When ironing fabrics with
mixed fabrics, set the iron
temperature for the most
delicate fabric.
- For delicate fabrics, we
recommend testing the fabric
first on an inconspicious place
for example, (inside the hem).
- If you want to iron without
steam, set the steam control
lever to .
• Your iron heats up quickly, therefore, begin ironing with fabrics that are
ironed at lower temperatures first, then go on to those requiring a
higher temperature.
F ABRIC
P OSITION OF
TEMPERATURE BUTTON
S TEAM SETTING
POSITION
LINEN MAX
C OTTON
•••
W OOL
••
SILK
•
S YNTHETIC
(Polyester, Acetate,
Acrylic, Polyamid)
Obtaining more steam
• Press the Burst of Steam button periodically to remove stubborn
wrinkles (
fig.7).
In order to achieve the
maximum amount of steam, it is
recommended that you wait a
few seconds after you push the
burst of steam button again.
Spray Function
• The Spray button (fig.8) will release a mist of water onto your
fabrics. Use this to remove stubborn wrinkles.
= STEAM ZONE
NOT FV32XX FTC 036635 5/12/06 11:39 Page 4