User's Guide

29
BIOS Setup option name Type [Default] / Select Value Show Help string
Advanced Page Yes
LAN 1 Select item [Disabled] / Enabled Yes Enable/Disable LAN1
LAN 2 Select item [Disabled] / Enabled Yes Enable/Disable LAN2
LAN 3 Select item [Disabled] / Enabled Yes Enable/Disable LAN3
MSATA Select item [Disabled] / Enabled Yes Enable/Disable MSATA
Wireless LAN RF Select item [Disabled] / Enabled Depend Enable/Disable Wireless Lan RF
Restore AC Power Loss
Select item Turn on / Turn off / [Last state] Yes
Select AC power state when power is re-applied
after a power failure.
DeepSx Power Policies Select item [Disabled] / Enabled Yes Configure the DeepSx Mode configuration.
OS Selection Select item [Windows]/Intel Linux Yes Select the target OS
SCC SD Card Support (D27:F0) Select item [Disable] / Enable No Enable/Disable SCC SD Card Support
HD-Audio Support Select item Disable / [Enable] Enable/Disable HD-Audio Support
DVMT Pre-Allocated
Select item [ 64M ]/ 128M / 256M / 512M Yes
Select DVMT 5.0 Pre-Allocated (Fixed) Graphics
Memory size used by the Internal Graphics Device.
DVMT Total Gfx Mem
Select item 128MB/ [256MB] / Max Yes
Select DVMT 5.0 Total Graphic Memory size used
by the Internal Graphics Device.
► Intel(R) I210 Gigabit Network Conection - …….. Yes Configure Gigabit Ethernet device parameters
► NIC Configuration Yes
Link Speed Select item
[Auto] / 10 Mbps Half / 10 Mbps Full
/ 100 Mbps Half /100 Mbps Full
Yes
Wake On LAN Select item [Enabled] / Disabled Yes
► NIC Configuration Yes
Link Speed Select item
[Auto] / 10 Mbps Half / 10 Mbps Full
/ 100 Mbps Half /100 Mbps Full
Yes
Wake On LAN Select item [Enabled] / Disabled Yes
► Battery Warning Support Yes Battery Warning Support
Low Battery Warning
Select item [Disable] / Enable Yes
Enable or Disable Low Battery Warning support.If
system boot without the adaptor and battery is low
during POST, system will shutdown after showing
warning in few seconds.
► Trusted Computing Yes Select fTPM/dTPM
TPM2.0 Device Found Board Infromation
Firmware Version: Board Infromation 7.2/301.9
Vendor : Board Infromation NTC/INTC
Line separator
Security Device Support Select item Disabled / [Enabled] Yes
Enables or Disables BIOS support for security
device. O.S. will not show Security Device. TCG
EFI protocol and INT1A interface will not be
available.
TPM Select Select item fTP M / [dTPM] Yes Select fTPM/dTPM