User's Manual

Once the initial Repeater placement is complete, the Sensor placement phase begins. Again the
LED feedback can be used to verify that MDT/Sensors are communicating with the network.
Additional repeaters can be placed in areas will minimal coverage. The Configuration Tool can
also be used in the placement phase to provide more detailed information such as Link Quality
and Signal Strength reading generated by MDT/Sensors and Repeaters. In particularly dense
sites such as in modern Hospitals, and Sniffer unit may be used to monitor local radio traffic. A
Sniffer is just a receiving unit that displays any received message on a Laptop over the same
UART interface used to configure MDT/Sensors.
Guidelines
Sensors can be mounted in a number of ways by utilizing velcro strips, tie-wraps, or screws.
Units may be mounted to the wall or other flat surfaces with screws or velcro, and strapped to
pipes or posts by placing tie-wraps through the two slots on the flanged case.
Units should not be placed directly on the metal surface unless no other option is available.
Mounting on a flat metal surface will significantly affect the performance of the device.
Notes
WAM User's Guide.pages! 4 of 4