User's Manual

47
User Interface Configuration
Select or enter the desired values by referring to DHCP Settings parameters table and
click on Apply Changes button to save the changes.
Table 20: DHCP Settings parameters
Parameter
Description
DHCP Mode
Allows you to set the DHCP mode by selecting the radio button
against 'DHCP Relay' and 'DHCP Server'.
DHCP Server: Enable the DHCP Server if you are using this device as a DHCP server.
This page lists the IP address pools available to hosts on your LAN. The device distributes
numbers in the pool to hosts on your network as they request Internet access.
IP Pool Range
Enter the range of IP Pool addresses in the text box provided. An
IP pool is a sequential range of IP addresses within a certain
network.
On clicking, Show Client button, Active DHCP Clients page is
displayed that shows the assigned IP address, MAC address and
time expired for each DHCP leased client. Following parameters are
displayed in Active DHCP Clients page:
 IP Address
 MAC Address
 Expired Time (sec)
Click Refresh button to reload the page.
Click Close button to close the page.
Subnet Mask
Allows you to enter the subnet mask in the text box provided.
Max Lease Time
Allows you to enter the maximum lease time in the text box
provided. When DHCP lease expires, it must renew the lease and
potentially receive a new IP address.
DomainName
Allows you to enter the domain name in the text box provided.
Gateway Address
Enter the gateway IP address, that refers to a device on a network
which sends local network traffic to other networks.
DNS option
Allows you to set the DNS option by selecting the radio button
against 'Use DNS Proxy' or 'Set Manually'.
 DNS Proxy: Takes DNS queries from a local network and
forwards them to an Internet Domain Name Server.
 Set Manually: Allows you to enter the IP address of DNS
servers, DNS1, DNS2, DNS3 individually in the text box
provided.
Port-Based Filter
On clicking this button, Port-Based Filter page is displayed that
is used to configure the Port-Based Filtering. Select the check box
against the desired port and click on Apply Changes button, to
save the changes.
Click Close button to close the page.