User's Manual
Table Of Contents
- Overview
- Introduction
- Hardware Architecture
- User Interface Configuration
- Basic Configuration
- LAN Interface Settings
- WLAN Configuration
- WAN Configuration
- Services
- VoIP
- Advance
- Admin
- Statistics
54
TJ2100N-14ET User Manual
Table 23: Traceroute Diagnostics parameters
Parameter
Description
Protocol
Select the protocol to be used from the drop down menu.
ICMP
UDP
Host Address
Allows you to enter the host address in the text box provided.
Number Of
Tries
Allows you to enter the number of attempts in the text box provided.
Time out
Enter the timeout in seconds.
Data Size
Enter the data size in bytes.
DSCP
Enter the DSCP value in the text box provided.
Max HopCount
Enter the maximum hop count in the text box provided.
WAN Interface
Allows you to select the WAN interface from the drop down menu.
Tracert6 (Trace route to a destination host using IPv6 traffic)
Go to Diagnostics->Tracert6 in the navigation pane. Traceroute6 Diagnostics page
is displayed. This page is used to print the route packets trace to network host. The
diagnostic result will be displayed.
Figure 26: Traceroute6 Diagnostics