User's Manual

90
TJ2100N-14ET User Manual
Table 42: IP/Port Filtering parameters
Parameter
Description
Outgoing Default
Action
Allows you to 'Deny' or 'Allow' outgoing default action by selecting
the desired radio button.
Incoming Default
Action
Allows you to 'Deny' or 'Allow' incoming default action by selecting
the desired radio button.
Direction
Select the direction of the port from the drop down menu.
 Outgoing
 Incoming
Protocol
Select the protocol to be used from the drop down menu.
 TCP
 UDP
 ICMP
Rule Action
Allows you to 'Deny' or 'Allow' rule action by selecting the desired
radio button.
Source Interface ID
Enter the identifier of the source interface.
Destination Interface
ID
Enter the identifier of the destination interface.
Source Port
Enter the source port in the text box provided.
Destination Port
Enter the destination port in the text box provided.
Current Filter Table
Entries in this table are used to restrict certain types of data
packets through the Gateway. Use of such filters can be helpful in
securing or restricting your local network.
Select the check box against the desired interface for deletion and
click on Delete Selected button.
To delete all configured interfaces on the pane, click on Delete All
button. Check box against all interfaces on the page will get
selected and will be deleted.
IPv6 ACL
Go to IPv6-> IPv6 ACL in the navigation pane. IPv6 ACL Configuration page is
displayed. This page is used to configure the IPv6 address for Access Control List. If ACL
is enabled, only the IP address in the ACL Table can access CPE. Here you can add or
delete the IP address.