User's Manual

Use flat bottomed pans and check that they
a re placed correctly on the pan support, in
o rder to prevent pans from sliding when their
contents start to boil (do not use pans with
concave or convex bases).
Hob models CG-Lux-75 and CG-Lux-86 are
p rovided with a special pan support which
p e rmits the use of concave-bottom pans
(woks).
The minimum diameter of the pans to be used
is 140 mm. For pans of 120 mm diameter or
less, use the small burner with the pan sup-
port supplement.
The electric hotplates are controlled by a
seven step switch. To obtain diff e rent powers
the corresponding control must be turned to
the desired setting. (See drawing 25).
The pan should be placed on the electric hot-
plate before it is switched on.
The powers corresponding to each setting of
the control knob are shown in the following
table:
Hotplate Ø 145 – 1500 W.
Control at Power
0 Disconnected
1 135 W.
2 165 W.
3 250 W.
4 500 W.
5 750 W.
6 1500 W.
These hobs have zones which become hot
during and after their use and can cause
burns.
The red-point hotplate (1,500 W) heats up
especially quickly and at its maximum power
during approximately the first five minutes.
After this time its power drops to 500 W and it
conserves the same temperature.
The control panel features a square drawing con-
taining circles beside each control knob, indica-
ting to which hotplate the control corresponds.
On the same panel there is a pilot light which
indicates the operation of one or more hotplates.
Hotplate operation pilot
Control indicator
Pilot light
When connecting the hotplate for the first time,
or if the plate has not been used in a long time,
it is necessary to dry out any humidity which
may have been absorbed by the insulation. To
achieve this, switch the hotplate on, without
any pan, for five minutes at power position 2.
TEKA Industrial, S.A. will accept no re s p o n s i-
bility for possible inaccuracies contained in
this instruction manual due to transcription or
printing errors.
It also re s e rves the right to make any modifi-
cations it considers necessary or useful to its
appliances without affecting their essential
characteristics.
26
Switching on Electric Hotplates
A
B
C
A
B
C
Drawing 25