Manual de Uso y Mantenimiento Manual de Utilização e Manutenção Use and Maintenance Manual Manual d'Emploi et Entretien Bedienungsanleitung und pilegehinweise Istruzioni sull’uso LP7 760 Code: 0120504497C
Index en 2 Safety information Installation 1 4 How to remove the top of your dishwasher 6 Getting to know your dishwasher 7 How to fill the salt 8 How to fill rinse aid 10 How to fill the detergent dispenser 11 Not suitable for the dishwasher 12 Arranging crockery, glasses, etc.
Safety information en At time of delivery Check packaging and dishwasher immediately for signs of transport damage. If the appliance is damaged, do not put it into use but contact your supplier or customer service without delay. Please dispose of packaging materials properly. During installation Site the dishwasher and connect it up in accordance with the installation instructions. The dishwasher must not be connected to the electricity supply while installation is being carried out.
en If your family includes children The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Keep detergents out of the reach of children, who must also be kept away from the dishwasher when it is open. If a fault occurs If the appliance malfunctions, turn off water supply to the appliance and disconnect the plug from the wall socket.
Installation en Positioning the appliance Positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to facilitate proper installation. Levelling the appliance Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the dishwasher, making it level.
en Drain hose connection Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run into the sink, making sure to avoid bending or crimping it. If necessary, fit a syphon trap (U-bend) with a connecting piece for the drain hose (fig.B). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in water. fig.
How to remove the top of your dishwasher en Please follow below pictures step by step.
Getting to know your dishwasher en Close-up view (control panel) C A B A ON-OFF Button C Programme Indicator B Programme Button Models explanation Model Colour LP7 760 White Dishwasher interior i a c e f k g d h b a 7 j Upper Rack g Washing Filter b Lower Rack h Detergent and Rinse Aid Dispenser c Top Spray Arm i Water Inlet Hose d Silverware Basket j Drain Hose e Bottom Spray Arm k f Salt Container Cap Power Supply Cord
How to fill the salt en Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loading the salt into the container Always use salt intended for use with dishwashers.
en Adjusting salt consumption The dishwasher is designed to allow for adjusting the amount of salt consumed based on the hardness of the water used. This is intended to optimize and customize the level of salt consumption so that it remains at a minimum.
How to fill rinse aid en Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door . When the low rinse aid indicator “ 1 ” is bright ,it means the rinse aid is low,you must load rinse aid . 1 Low Full Loading the rinse aid Regardless of the type of detergent dispenser installed on your appliance, you must proceed as indicated below when loading the rinse aid.
How to fill the detergent dispenser en Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Programme overview". The detergent dispenser is located on the inside panel of the door. 5 4 Loading the detergent To open the " 4 " cover on the dispenser, press the " 5 " button. The detergent for the wash cycle should be poured into the " 6 " compartment.
Not suitable for the dishwasher en What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Delicate decorative glassware and vases,special antique or irreplaceable china. The decorative patterns on such items will not be dishwasher-proof.
Arranging crockery, glasses, etc. in the dishwasher en Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before washing. This will eliminate the need for extra wash cycles. Pull out the rack to load the dishwasher.
en Shelf Lean tall glasses and those with long stems against the shelf- not against other items to be washed. Place glasses, cups and small bowls on the additional cup rack. The additional cup rack can be swivelled in or out as required (see fig.E). fig.E Knife rack The knife rack clips onto the side of the top basket, giving you the freedom to wash your large sharp knives separately and out of harm’s way (see fig.F).
Programme overview Type of crokery e.g. Wash china, pots/ pan s, programme cutiery, glasses, etc Non- Intensive Wash delicate Type of Amount of food food remains remains Soups, casseroles, sauces, potatoes, pasts, rice, eggs, roast or fried food. Soups, potatoes, pasta, rice, eggs, roast or fried food. Normal Wash (EN50242) en Condition of food remains Description of cycle Pre-wash with hot water. a lot stuck on Extended wash at 70°C. Rinses with cold water. hard Rinse with hot water.
en Detergent Energy Water consump- consump- tion in kWh tion in litres Extended Wash Prewash Duration in minutes 30g 7.5g 112 1.62 18 20g 5g 94 1.48 16 30g 7.5g 162 1.10 16 20g 5g 142 1.00 13 15g 31 0.40 9 10g 29 0.30 8 12 0.02 3 12 0.
Washing dishes en Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumption details are shown in the right half of the overview. For example: Use the« normal» programme for dishes and utensils which have plenty of food remains stuck on hard.
en Switching the dishwasher ON Turn on the tap. Set ON-OFF button “ A ” to ON, the dishwasher beeps one time, All indicators “C1,C2,C3,C4,C5 ” light . Press programme button “B1”, programme indicator “ C1” light. A C1 C2 C3 C4 C5 If the door is closed, after 3 seconds, the programme indicator “ C1” will blink and the dishwasher beeps one time, then the programme starts automatically. B1 End of programme Six beeps will indicate that the wash cycle has finished and all the indicators light.
en 1/2 Load Button This button “B5” (see" Close-up View (Control Panel), letter " B ") makes it possible to wash dishes using only the upper rack if there are not enough dishes for a full load. This will allow you to save on water and energy consumption. To select 1/2 load: Select the programme ( see the paragraph entitled“ Switching the dishwaher ON”) Press the 1/2 load button “ B5 ” , 1/2 load indicator “ C5 ” lights. If the door is closed, after 3 seconds, the programme starts automatically.
How to keep your dishwasher in shape en After Every Wash After every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always remove the plug from the socket. Do not run risks. No solvents or Abrasive Cleaning Products To clean the exterior and rubber parts of the dishwasher, do not use solvents or abrasive cleaning products.
Care and maintenance en Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance Check that no grease or scale has accumulated on the inside of the dishwasher. If you discover any deposits: Clean the interior of the dishwasher thorughly with a detergent solution.
Fault finding en Resolving minor problems yourself Experience has shown that you can resolve most problems that rise during normal daily usage yourself, without having to call out a service engineer.Not only does this save costs,but it also means that the appliance is available for use again that much sooner. The following list of common occurrences and their remedies should help you identify the causes of most problems. Problems... ...
en When the programme indicators “ C1,C3,C4” blink. Have you checked whether: C1 C3 C4 the drain hose is crimped or bent. the drain hose is too high. When the programme indicators “ C1,C4” blink. Have you checked whether: C1 C4 the drain hose is too low. If you have made all these checks and the dishwasher still does not function or your dishwasher has another error display.
en Water remains inside appliance after programme has ended Blockage or kind in drainage hose. Pump is jammed. Filters are blocked. The programme is still running. Wait for the programme to end . ...during washing Unusual amount of foam is creased Normal washing up liquid has been poured into the rinse-aid container. Remove any spilled rinse aid with a cloth as it could otherwise lead to excessive foaming during the next washing cycle.
en Plastic items are discoloured Not enough detergent was added to dispenser. Detergent has insuffcient bleaching properties. Use a detergent containing a chemical bleaching agent. White stains are left on crockery, glasses have a milky appearance Not enough detergent was added to dispenser compartment. Amount of rinse-aid was set too low. Although water is quite hard, no salt has been put in appliance. Water softener was set too low. Lid on salt container is not screwed tight.
Technical data en Width 60 cm Depth 60 cm Height 85 cm Capacity Mains water pressure Power voltage Maximum current intensity Total absorbed power 15 standard place settings 0.03-0.6MPa 220-240V~ 50Hz 10A 1950W Important information Notes on waste disposal Old appliances still have some residual value. An environment-friendly method of disposal will ensure that valuable raw materials can be recovered and used again.
en General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the adjacent cupboards. For Switzerland only: There are no restrictions on installing the appliance between wooden or plastic walls as part of a fitted kitchen.
en CnP4 CnP2 A: Wiring box B: Door switch C: Water level switch D: Drain pump motor E: Dispenser F: Softener valve G: Overflow switch H: Inlet valve I: Washing pump motor J: Temperature limiter K: Heater L: Relay M: Flowmeter N: Temperature sensor O: 2-way valve