User's Manual

Page 35 Page 36
3 Press the CH knob to confirm the new channel name, then press cancel
to return t o the menu.
6.8.2 RING VOLUME ADJUSTMENT
1 Select the RING VOLUME by CH knob and then display the
option – HIGH and LOW as ringer tone setting.
2 Press The CH knob key again to confirm the changes.
6.8.3 BEEP VOLUME ADJUSTMENT
1 The key beep tone volume level. Select the BEEP VOL by The CH
knob and then display the option – HIGH, LOW & OFF as key beep
setting.
2 press The CH knob key again to confirm the changes.
6.8.4 INTERNAL SPEAKER ON/OFF
on/off the internal speaker in case external speaker is used.
1 Select the RADIO SETUP then INT SPEAKER.
2 Select ON (on) or OFF (off) then press The CH knob key to enable the
setting and return to the menu.
6.9 DSC SETUP
The submenu is used to set behavior of the DSC/ATIS function.
The following 6 items are available for selection.
User MMSID
Group MMSID
INDIV REPLY
DSC ENABLE
POS REPLY
6.9.1 ENTER YOUR USER MMSID(USER MMISD)
This is a once-only operation.
You must enter your user MMSID first then you can access the DSC
functions.
1 Select DSC SETUP then USER MMSID and press the CH knob. If
an existing MMSID is stored, the values appear.
2 If the MMSID is blank, a dashes line will appear. Enter user MMSID
along the dashed line. Press the CH knob to confirm each correct
entry to move to the next digit.
If your make an error, press –until < appears, then press the CH
knob to backup and correct the entry.
3 Hold the CH knob to store your user MMSID.
4 Enter your user MMSID again as a password check, hold the CH knob to
permanently store the your user MMSID and return to the menu.
5 You can view your stored user MMSID at anytime by selecting user
MMSID in the main menu.
6 If there is no USER MMSID stored and the radio’s DSC function is
attempted, the radio says “DSC IS NOT OPERATIONAL.” & “ENTER
MMSID!” as below.
DSC WARNING MESSAGE
DSC IS NOT
OPERATIONAL.
ENTER MMSID
!
CALLING
DISPLAYNAME
>CH INFO
DISPLAY NAME
>ON
OFF
CH NAME
>RING VOL
BEEP VOL
INT SP
K
RING VOLUNE
>LOUD
SOFT
CH NAME
RING VOL
>BEEP VOL
INT SPK
BEEPVOLUME
>HIGH
LOW
OFF
CH NAME
RING VOL
BEEP VOL
>INT SPK
INT SPK
> ON
OFF
INPIT MMSI
NUMBER
>- - - - - - - -
HOLD ENTERR
USER MMSID
INPUT AGAIN
>- - - - - - - -
HOLD ENTERR
USER MMSID
ID 50000000
>SAVE
CANCEL