User manual
There may be various reasons for occurring abnormal operation of the receiver. Check the receiver according to
the procedures shown below. If the receiver does not work properly after checking it, please contact the dealer.
Don’t open the receiver cover. This may cause a dangerous situation and will void warrant
The display on front
panel does not light up.
The power cord is not plugged in.
Receiver is in stand-by mode.
Your model is without display.
Check, that the power cord is plugged
into the wall outlet.
Switch ON receiver.
Your model is without display.
No picture or sound Wrong connection of the Audio/Video
output of the receiver to TV.
Connect the Audio/video output of the
receiver to TV correctly.
Audio muting.
Wrong Audio channel
Press the Mute button.
Press AUDIO button and select other
audio channel
TV power off, wrong channel or input. Turn on TV, select correct channel
or input.
No picture The receiver can’t receive the signal Check the antenna cable, replace the
cable, or connect the cable to the
receiver tightly.
Incorrect values of some
tuner parameters.
Set the values of the tuner parameters
correctly in the installation menu.
Wrong direction of the dish Check the signal strength with a
spectrum analyzer and adjust your
dish correctly.
The remote control does
not work
The batteries of the remote control are
not inserted or exhausted
Check whether the batteries are
inserted correctly in your remote
control. Check the batteries, and if
exhausted replace the batteries in the
remote control.
The USB storage device
is not recognized.
Wrong formatted Make sure that your USB device use le
system FAT32.
The external USB HDD
does not start.
Power consumption is too high. Connect extra power supply adaptor to
your USB HDD.
The receiver switches
off automatically.
Auto Standby function enabled. Disable Auto Standby. See section 4.1.4
for details.