User manual
17.
For Teletext and further menu
functions
18. In viewing mode toggles
between TV and radio mode
Fig. 5
Remove the battery cover from the remote
control and put 2xAAA size batteries inside
the compartment.
The diagram inside the battery compartment shows
the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
Fig. 4
To use the remote control, point it towards the front
of the digital receiver. The remote control has a range
of up to 7 metres from the receiver at an angle of up
to 60 degrees.
The remote control will not operate if its path
is blocked.
Sunlight or very bright light will
decrease the sensitivity of the
remote control.
Fig. 6
Connecting a xed satellite dish to your receiver
Fig. 7
Connecting multiple xed dishes to your receiver
using a DiSEqC 1.0 switch Fig. 8
Connect your Digital Audio Amplier with the S/PDIF
connector on the back of the receiver Fig.7
Fig. 9
Ensure your satellite signal is of good quality. It
is recommended that you perform the rst time
installation by following the Installation as described
step by step. It will help you to easily achieve system
conguration and installation setup.
Press pq and tu to change settings for OSD
Language, Audio Language, Subtitle Language,
AUTO Standby, Auto Time Zone and Time Zone.
Use this option to change the language of the OSD.
Use tu to select OSD language to German, French
or English.
Use this option to change the language of the Audio.
Use tu to select Audio language to German, French
or English.
Use this option to change the language of Subtitles.
Use tu to select Subtitle language to German,
French, English or OFF.
This option allows you to enable Auto Standby or to
disable Auto Standby. Auto Standby will switch the
receiver to standby automatically when it doesn’t
receive commands from the remote control for a
period of 3 hours. To avoid the automatic switch off,
use tu to set Auto Standby to OFF.